6 Mayıs 2012 Pazar

Stepper motor drive

To contact us Click HERE
Stepper motor driveIntegrated circuits intended to drive stepper motors are many and are rather easy to operate because they contain both logical circuits and power circuits in the same chip. You just have to choose the circuit corresponding to the type of stepper motor you want to use, namely unipolar (6 wires) or bipolar (4 wires).
In the first case, we can use a SAA on 1027 (difficult to find now) or a more powerful UCN 5804. For the bipolar motor, the SAA 1042 (idem) or the MC 3479 will be quite indicated. Most of these controllers allow to work in half-step mode.It is to note also that we can drive a unipolar motor with a controleur for bipolar motor but that the opposite is not possible.We propose here a plan of driver for unipolar motor realized with 2 common logic components and a power circuit. It is possible to drive motor needing 500 mA by coil, what should be sufficient in the present frame!
Pin Assignments for CD4070
  1. In 1
  2. In 1'
  3. Out 1
  4. Out 2
  5. In 2
  6. In 2'
  7. Ground
  8. In 3
  9. In 3'
  10. Out 3
  11. Out 4
  12. In 4
  13. In 4'
  14. +Vcc
Pin Assignments for CD4013
  1. Out 1
  2. Out inv 1
  3. Clock 1
  4. Reset 1
  5. Data 1
  6. Set 1
  7. Ground
  8. Set 2
  9. Data 2
  10. Reset 2
  11. Clock 2
  12. Out inv 2
  13. Out 2
  14. +Vcc
 Pin Assignments for CD4093
  1. In 1
  2. In 2
  3. In 3
  4. In 4
  5. In 5
  6. In 6
  7. In 7
  8. Ground
  9. +Vcc
  10. Out 7
  11. Out 6
  12. Out 5
  13. Out 4
  14. Out 3
  15. Out 2
  16. Out 1


Components listIC :
quad. XOR = CD 4070 or 4030
Dual shift register = CD 4013
Ampli = ULN 2003
Unipolar stepper motor
Stepper motors can be found on old floppy disk drives or printers for example. In certain cases we can even use the controllers who are joined to it. 2 control pulses can result from a microcomputer (parallel port) + line buffers.
Gönderen zaman:

Hiç yorum yok:

Yorum Gönder

Kaydol: Kayıt Yorumları (Atom)